Jeep TJ fender flares are important. They protect your Jeep from mud and stones. Sometimes, you need to remove them. Maybe to clean or replace them. This guide will help you do that.
Why Remove Fender Flares?
Fender flares help your Jeep look great. They also stop dirt from flying. But there are reasons to remove them:
- You want to paint them.
- You need to clean behind them.
- You plan to install new ones.
- The old ones are broken or worn out.
Credit: wranglertjforum.com
Tools You Need
Before you start, gather these tools:
Tool | Purpose |
---|---|
Screwdriver | To remove screws |
Socket Wrench | For bolts and nuts |
Safety Glasses | To protect your eyes |
Work Gloves | To protect your hands |
Steps to Remove Fender Flares
Follow these steps. They will help you remove the fender flares safely.
Step 1: Prepare Your Jeep
Park your Jeep on a flat surface. Turn off the engine. Make sure the Jeep is stable. You don’t want it to move.
Step 2: Wear Safety Gear
Put on your safety glasses and gloves. This will keep you safe while working.
Step 3: Locate The Screws
Find the screws holding the fender flares. They are usually on the inner edge of the flare. There may be several screws. Check carefully.
Step 4: Remove The Screws
Use the screwdriver to remove the screws. Turn the screwdriver counterclockwise. Be careful not to strip the screws. Put the screws in a safe place. You might need them later.
Step 5: Unbolt The Flares
After removing the screws, find the bolts. Use the socket wrench to remove them. Turn the wrench counterclockwise. Keep the bolts safe too.
Step 6: Gently Remove The Flares
Once all screws and bolts are out, gently pull the flare. Be careful not to break it. If it feels stuck, check for missed screws or bolts.
Step 7: Clean The Area
With the flare off, clean the area. Remove any dirt or rust. This will help the new flares fit better.
Step 8: Inspect The Flares
Look at the fender flares you removed. Check for cracks or damage. Decide if you want to reuse them or get new ones.

Credit: www.youtube.com
Tips for Success
Here are some tips to make your work easier:
- Take your time. Rushing can lead to mistakes.
- If a screw is stuck, use a penetrating oil. This can help loosen it.
- Label your screws and bolts. This helps if you plan to put the flares back.
- Have a friend help. Two pairs of hands make the job easier.
Frequently Asked Questions
How Do You Remove Jeep Tj Fender Flares?
Start by unscrewing bolts and clips. Gently pull the flare away.
What Tools Are Needed For Fender Flare Removal?
A socket wrench, flathead screwdriver, and a trim removal tool.
Can I Reuse My Old Fender Flares?
Yes, if they are in good condition. Check for cracks or damage.
How Long Does It Take To Remove Fender Flares?
Usually around 30-60 minutes per flare. Depends on experience.
Conclusion
Removing Jeep TJ fender flares is not hard. With the right tools and steps, you can do it. This guide helps you protect and upgrade your Jeep. Keep your Jeep looking great and performing well. Enjoy the process!
Leave a Reply